FORUM JAGUAR CLUB POLAND FOUNDATION
Dział Techniczny => X-TYPE (2001-2010) => Wątek zaczęty przez: Mateo520 w Sierpień 21, 2013, 16:27:06 pm
-
Witam,
od jakiegoś czasu w jagu świeci się kontrolka abs. Przy rozbieraniu czujników z przodu wyszło, że ani jeden ani drugi nie ma rezystancji. Czujniki w x-typie są indukcyjne czy hallotronowe? Jeżeli indukcyjne to chyba powinny mieć jakąś wartość rezystancji?
Na komputerze wyskoczyły następujące błędy: C1165 , P0480, P1582, U1165, U2510, U2511, U1900.
-
C1165 Anti-lock braking control module
Anti-lock braking RH rear wheel speed sensor circuit fault
RH rear wheel speed sensor circuit: open circuit, short circuit to B+ V, short circuit to ground
U2510 Instrument cluster
System PATS
PATS ECM identification mismatch. Security LED flash code 23
Reconfigure ECM using WDS
Incorrect ECM installed
U2511 Instrument cluster
System PATS
PATS ECM invalid data
Reconfigure ECM using WDS
Incorrect ECM installed CAN network error
U1900 Instrument cluster
Instrumentation
CAN instrumentation messages missing
Verify integrity of EMS, ABS, DSC
CAN network fault
P0480 Radiator cooling fan module drive circuit malfunction
ECM to radiator cooling fan module drive circuit: short circuit, open circuit, high resistance
Radiator cooling fan module fault
P1582 “Flight recorder” data is stored if any one of five conditions occur:
1 Inertia switch activated
2 Throttle Limp Home mode
3 Engine starts and stumbles
4 Engine fail to start
5 Engine stall
If none of the five conditions occur, check: Inertia switch to ECM circuit, short circuit to B+ voltage
Inertia switch failure
-
ok, wygląda na to że w tylnym kole jest przerwa.
Co do błędu P0480 to chyba poszła pompa klimatyzacji, klima nabita ale mrozić nie chcę, a wentylatory pracują nawet na zapłonie przy wyłączonej klimatyzacji.