Dział Techniczny > XJ-40, XJ-81 (1986-1994)
wysokie obroty
grochu27350:
Jeśli masz tempomat , spróbuj odłączyć cięgno z tej gumowej bańki , od przepustnicy , może coś ze sterowania tempomatu padło i cały czas ci ciągnie.
katar83:
Przeciez trzeba ustawic teraz.
1. Run engine until fully warm. (AC and any other powered items off. In Park.
2. Switch off ignition.
3. After 5 seconds switch the ignition on again (do not start)- wait 5 seconds then remove connector from stepper motor.
4. Switch off ignition.
5. Wait 15 seconds then replace connector on stepper motor.
6. Repeat operation sequence 3 - 5 twice - on the last occasion do not reconnect stepper motor.
7. Start engine and set base idle to 550 - 600 r.p.m. via air bypass adjuster. (You will need a 7/32 (5.5mm) Allan key)
8. Switch ignition off and reconnect idle stepper motor.
9. Restart engine - idle speed should now stabilise around speed I mentioned before.
Nawigacja
Idź do wersji pełnej